Password Verification; Card Verification - ZKTeco K Series User Manual

1.3.2 Password Verification

In the password verification mode, the terminal compares the password entered with that in relation to the user ID.
Enter the user ID on the initial
interface. Then press [M/OK] to
enter the enrolled PWD properly.
Notes:
If the device says "Incorrect password", enter the password again. You can try another 2 times by default. If it fails after 3
times, return Step 1 for second operation.
1.3.3 Card Verification 
It is optional function. If needs, please contact business representative or pre-sales engineer, you can use this function
after obtaining license and activating.
K Series devices have an embedded ID or Mifare card module, providing the verification function. A device compares the
read card ID with all card IDs enrolled in the device during verification.
If the verification is successful, the
interface as shown above.

Notice: The card area is round the fingerprint sensor.
K Series Economic Models User Manual
When verification successful, the
interface shown as figure 2.
If the verification is not successful,
the interface as shown above.
When verification failed, the
interface shown as figure 3.
Note: If a device is connected to a
computer through a USB cable, the Mifare
card of the device is unavailable and a text
prompt message is displayed on the initial
interface. The Mifare card restores after the
device is disconnected from the computer.
3