Timing State Switching Setting - ZKTeco K Series User Manual

7 System Setting
Press ▼ key to select Comm. Set
and press [M/OK] key to enter the
Comm. Set interface as following:
Parameters in Comm. Set interface state as following:
IP Address: The IP address is 192.168.1.201 by default and can be changed as required.
Subnet Mask: The subnet mask is 255.255.255.0 by default and can be changed as required.
Gateway: The gateway is 0.0.0.0 by default and can be changed as required.
DHCP: ON or OFF. When set as ON DHCP, then the device automatically obtain an IP address.
Password: To enhance the security of attendance data, you can set a password for the connection between the device
and PC. Once the password is set, you can connect the PC with the device to access the attendance data only after
entering the correct password. The default password is 0 (that is, no password). Once a password is set, you need to
enter this password before connecting the PC software with the device; otherwise, the connection is unsuccessful. 1 to 6
digits passwords are supported
Operation of Comm. Set interface:
Press ▲/▼to move cursor to the item to be set. If it is the input box, press numeric keys to input the value. If it is the roll
box, press to switch the values. After setting, press [M/OK] key to save or press [ESC] to cancel setting and return to
the previous interface.

7.4 Timing State Switching Setting

When it comes the set times, the attendance machine will automatically switch its attendance state. The current
attendance state is shown on the initial interface.

Note: The attendance status is downloaded together with attendance records. Users can view the attendance status
by using attendance software. The attendance status does not affect attendance calculation, which is based on the preset
shift time.
SSR Type
26
No-SSR Type
On the System interface, press ▼ key to
select Auto Switch and press [M/OK] key to
enter the Auto Switch interface, shown as
following figure 2: