Upload Att. Setting Report - ZKTeco K Series User Manual

6 Report Management
on the right of the Schedule Setting Report, where shifts 1–24 are shifts those set in the Attendance setting report and
shift 25 is for leave and shift 26 is for out.

Notes:
1. The shifts of only 31 days can be arranged in one schedule setting report. For example, if the scheduling date is
2013-1-1, the schedule setting report contains the schedules of 31 days after 2013-1-1, that is, schedules from
2013-1-1 to 2013-1-31. If the scheduling date is 2013-1-6, the schedule setting report contains the schedules of 31
days after 2013-1-6, that is, schedules from 2013-1-6 to 2013-2-5.
2. If no schedule setting report is set, all employees use the Shift 1 by default from Monday to Friday.

6.3 Upload Att. Setting Report

Press ▼ key to select Upload Att.
Setting Report, then press
[M/OK] to uploading table.
The employee information, shifts, and departments in the setting report can be viewed either on User, Shift set, and Dept
set interface of the device or in downloaded standard reports.

Note: If the schedule time format is incorrect, a prompt box shown in the following figure will be displayed:
Press [M/OK] key to confirm and close the prompt box. Re-upload the attendance setting report after modification.
22
Uploading table......
For the correct schedule time format, see "What is the
correct time format used in the setting reports" in the
Appendix 3 K Series Economic Models
Data upload succeed! Press [M/OK]
key to close the prompt box, and then
take out the USB disk.
FAQs.