Danfoss VLT FC 300 Operating Instructions Manual page 17

FC 300 Extended Relay Card Operating In-
structions
[83] SL Digital Output D
[84] SL Digital Output E
[85] SL Digital Output F
[120] Local reference active
[121] Remote reference active
[122] No alarm
[123] Start command active
[124] Running reverse
[125] Drive in hand mode
[126] Drive in auto mode
E-24 Function Relay
Array [9]
(Relay 1 [0], Relay 2 [1], Relay 3 [2], Relay 4 [3], Relay 5 [4], Relay 6 [5], Relay 6 [5], Relay 7 [6], Relay 8 [7], Relay 9 [8])
Option:
[0] * No operation
[1] Control ready
[2] Drive ready
[3] Drive rdy/rem ctrl
[4] Enable / no warning
[5] Drive running
[6] Running / no warning
[7] Run in range/no warn
[8] Run on ref/no warn
[9] Alarm
[10] Alarm or warning
[11] At torque limit
[12] Out of current range
[13] Below current, low
[14] Above current, high
[15] Out of speed range
[16] Below speed, low
[17] Above speed, high
[18] Out of feedb. range
[19] Below feedback, low
[20] Above feedback, high
[21] Thermal warning
[22] Ready,no thermal W
Controller Action
See par. LC-52 Logic
Set dig. out. A high is executed. The input will go low whenever the Smart Logic Action [35]
dig. out. A low is executed.
See par. LC-52 Logic Controller Action
Set dig. out. A high is executed. The input will go low whenever the Smart Logic Action [36]
dig. out. A low is executed.
Controller Action
See par. LC-52 Logic
Set dig. out. A high is executed. The input will go low whenever the Smart Logic Action [37]
dig. out. A low is executed.
Output is high when par. F-02 Operation
= [0] Linked to hand auto at the same time as the is in Hand on mode.
Output is high when par. F-02 Operation
the is in [Auto on] mode.
Output is high when no alarm is present.
Output is high when there is an active Start command (i.e. via digital input bus connection or [Hand
on] or [Auto on]), and no Stop or Start command is active.
Output is high when the frequency converter is running counter clockwise (the logical product of
the status bits 'running' AND 'reverse').
Output is high when the frequency converter is in Hand on mode (as indicated by the LED light
above [Hand on]).
Output is high when the frequency converter is in Hand on mode (as indicated by the LED light
above [Auto on]).
Function:
MI.33.G2.02 - VLT® is a registered Danfoss trademark
. The input will go high whenever the Smart Logic Action [41]
. The input will go high whenever the Smart Logic Action [42]
. The input will go high whenever the Smart Logic Action [43]
Method
= [2] Local or when par. F-02 Operation
Method = Remote Linked to hand/auto
[1] or
5. Parameter Set-up
Set
Set
Set
Method
[0] while
5
17