Info Menu And Operational Status Codes - Worcester Greenstar i System ErP Series Installation, Commissioning And Servicing Instructions

Commissioning
SCREEN DISPLAY
All possible screen symbols
Alpha/Numerical display
Text display
Right hand arrows (text display) Use DHW-arrow buttons to alter the
Flashing T (text display)
Flashing A (text display)
Hot water
Central Heating
Chimney sweep mode
Alert
Service mode
Burner on
Centigrade
°C
Confirmation
Table 30 Symbol description
38
DESCRIPTION
This screen is displayed briefly
during appliance start up and shows
all the symbols that could be
displayed.
Displays a temperature or appliance
status code.
Displays status, diagnostic code and
short description information
menu item (view mode)
Appliance in component test mode
Appliance in air purge mode
Displays this symbol during a DHW
cylinder use (only available when
optional integral diverter valve kit
fitted).
Displays this symbol during a CH
use.
Displays during service when the
appliance is set to maximum or
minimum output.
Displays with the appliance status
code and diagnostic code during a
fault condition.
Displays when appliance is in
service menu mode. For qualified
engineers only.
The appliance is in operation and the
flame is alight.
Displays next to the temperature
reading.
This symbol confirms a setting
change.
Available menus
Text line display Description
Various info (Info Menu) Information from current status to
appliance and component output
readings, ( section 6.4.2, page 38).
Benchmark Menu Information for filling in Benchmark
section, ( section 6.5.11, page 44).
Boiler Setting Appliance setup parameters,
( section 6.5.13, page 45).
Master Settings Appliance power output parameter,
( section 6.5.14, page 46).
Test Menu Component test function menu,
( section 7.1.2, page 50).
Weather Sensor Settings Outdoor weather sensor setup
parameters, ( section 6.5.12, page 44).
Various info (History History of appliance errors and operational
Menu) time, ( section 7.1.1, page 49).
Reset to Factory Settings? Factory reset function.
Table 31 Available menus
6.4.2

Info menu and operational status codes

These are not faults, but provide information concerning the current
status of the appliance.
During normal appliance operation various Status codes can be
displayed by entering the Info menu, Status code list ( table 33,
page 39).
The first screen of the Information menu displays the current Status
code, this will change as the appliance runs through the various modes
and sequences.
▶ Press the button to enter Info menu function.
▶ Using the DHW up/down arrow buttons to scroll through the menu.
▶ Press the button to leave the info menu.
Greenstar i System - 6 720 806 945 (2015/07)
ErP