Sony PEG-N770C/E Operating Instructions Manual page 81

Using your CLIÉ handheld
Which port number is allocated to the infrared port. Check the infrared port number in the Infrared


Monitor in the Control Panel. For information on the Infrared Monitor, see the manual of the computer
you are using or the Windows
Preparing your computer
To perform an IR HotSync
To allocate a virtual port to an IR HotSync
1 Click the HotSync
Local from the shortcut menu.
2 Click the HotSync
menu.
The Setup dialog box is displayed.
3 Click the Local tab to change the setting for an IR HotSync
Serial Port specifies a virtual port for an infrared port. If you are not sure of the connection port,


see the Infrared Monitor in the Windows
Speed determines the speed at which data is transferred. Try the As Fast As Possible rate first, and


then adjust downward if you experience problems.
4 Tap OK.
Your computer is ready to perform an IR HotSync


When performing a local HotSync
restore the local HotSync
Performing an IR HotSync
When you have prepared your computer and your CLIÉ handheld, as well as selected your Conduit Setup
options, you are ready to perform an IR HotSync
®
online help.
®
operation, you have to allocate a virtual port to an IR HotSync
®
operation, proceed as follows:
®
icon in the Windows
®
icon in the Windows
®
operation with the cradle after you make the HotSync
®
settings. For details, see Restoring the local HotSync® settings
®
operation
®
system tray (bottom-right of the taskbar) and then select
®
system tray again and then select Setup from the Shortcut
®
operation as needed.
®
Control Panel.
®
operation.
®
Setup settings for an IR HotSync
®
operation.
®
operation.
®
operation, you should
(page 81).
n N
80