Configuring Vlan Mapping - ZyXEL Communications XS3800-28 User Manual

Table 143 Advanced Application > VLAN Mapping (continued)
LABEL
Port
*
Active
Apply
Cancel

29.3 Configuring VLAN Mapping

Click the VLAN Mapping Configure link in the VLAN Mapping screen to display the screen as shown. Use
this screen to enable and edit the VLAN mapping rule(s).
Figure 255 Advanced Application > VLAN Mapping > VLAN Mapping Configuration (Standalone
Mode)
Chapter 29 VLAN Mapping
DESCRIPTION
This field displays the port number. In stacking mode, the first number represents the slot ID and
the second is the port number. Please note that the default stacking ports (the last four ports of
your Switch) cannot be configured. They are reserved for stacking only.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the VLAN mapping feature on this port. Clear this check box to
disable the VLAN mapping feature.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XS3800-28 User's Guide
333