Classifier Global Setting Configuration - ZyXEL Communications XS3800-28 User Manual

Table 88 Common Ethernet Types and Protocol Number
ETHERNET TYPE
IBM SNA
AppleTalk AARP
Some of the most common IP ports are:
Table 89 Common IP Ports
PORT NUMBER
21
23
25
53
80
110

21.4 Classifier Global Setting Configuration

Use this screen to configure the match order and enable logging on the Switch. In the Classifier
Configuration screen click Classifier Global Setting to display the configuration screen as shown.
Figure 176 Advanced Application > Classifier > Classifier Configuration > Classifier Global Setting
The following table describes the labels in this screen.
Table 90 Advanced Application > Classifier > Classifier Configuration > Classifier Global Setting
LABEL
Match
Order
Logging
Active
Interval
Chapter 21 Classifier
PROTOCOL NUMBER
80D5
80F3
PORT NAME
FTP
Telnet
SMTP
DNS
HTTP
POP3
DESCRIPTION
Select manual to have classifier rules applied according to the weight of each rule you configured in
Advanced Application > Classifier > Classifier Configuration.
Alternatively, select auto to have classifier rules applied according to the layer of the item
configured in the rule. Layer-4 items have the highest priority, and layer-2 items has the lowest priority.
For example, you configure a layer-2 item (VLAN ID) in classifier A and configure a layer-3 item
(source IP address) in classifier B. When an incoming packet matches both classifier rules, classifier B
has priority over classifier A.
Select this to allow the Switch to create a log when packets match a classifier rule during a defined
time interval.
Select the length of the time period (in seconds) to count matched packets for a classifier rule. Enter
an integer from 0-65535. 0 means that no logging is done.
XS3800-28 User's Guide
233