Source - ZyXEL Communications XS3800-28 User Manual

The following table describes the labels in this screen.
Table 70 Advanced Application > Mirroring > RMirror
LABEL
Active
RMirror VLAN ID
Apply
Cancel
VLAN
Active
Delete
Cancel

16.1.3 Source

Use this screen to configure the reflector port and specify the traffic flow to be copied to the monitor
port when the Switch is the source device in remote port mirroring.
Click the Source link in the RMirror screen. The following screen opens.
Chapter 16 Mirroring
DESCRIPTION
Select the option to enable the VLAN.
Specify the ID number of remote port mirroring (RMirror) VLAN.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the nonvolatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the ID number of the RMirror VLAN. Click on the VLAN ID number to change
the settings.
This field displays whether the VLAN is enabled or not.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Check the rule(s) that you want to remove and then click the Delete button.
Click Cancel to clear the selected checkbox(es).
XS3800-28 User's Guide
189