Extended Menu Operations - Sony XDCAM HD PDW-HD1500 Operation Manual

Item number Item name
959
H/V RATIO (UC)
965 INPUT UP CONVERT IMAGE
ENHANCER
Sub-Item
1
ENHANCER SETTING
2 UP CONVERTER MODE
3 H CROP POSITION (IN UC)
4 LETTER BOX POSITION (IN
UC)
5 UP CONVERTER PROCESS
6 DETAIL GAIN (IN UC)
7 LIMITER (IN UC)
8 CRISP THRESHOLD (IN UC)
9 LEVEL DEPEND
THRESHOLD (IN UC)
10 H DETAIL FREQUENCY (IN
UC)
11 H/V RATIO (IN UC)
a) When the separately sold PDBK-S1500 option is installed.
118
Setup Menu
Menu items in the 900s, relating to digital process
Settings
Adjust the up-converter image enhancer. Set the horizontal/vertical ratio
a)
for edge enhancement.
0 to 3 to 7
Set up the operation of the up converter image enhancer for SD input,
separately from the settings for playback (menu items 950 to 959).
a) PB: While SD signals are input, make the behavior of the image
enhancer of the up-converter follow the settings for playback (menu
items 950 to 959) (Settings for sub-items 2 to 11 under menu item
965 become invalid).
INPUT: While SD signals are input, make the behavior of the image
enhancer of the up-converter follow the settings for sub-items 2 to 11
under menu item 965 (separate settings during input of SD signals
from those during playback).
Select the up-converter mode.
crop: Select the edge-crop mode.
l-box: Select the letter box mode.
squez: Select the squeeze mode.
When sub-item UP CONVERTER MODE of menu item 965 is set to
"crop", adjust the H-crop (horizontal crop) position for up converter output
in edge crop mode.
–120 to 0 to 120
When sub-item UP CONVERTER MODE of menu item 965 is set to "l-
box", adjust the vertical location of the position where the picture is cut
out for up converter output in letter box mode.
–120 to 0 to 120
Select the source picture to use in converting SD to HD.
field: Use field pictures.
adapt: Frame or field is selected automatically.
Adjust the up-converter image enhancer. Set the sharpness of edge
enhancement.
0 to 40H to 7FH
Adjust the up-converter image enhancer. Set the maximum detail level
added to emphasize the original signal.
0 to 20H to 3FH
Adjust the up-converter image enhancer. Set the threshold amplitude at
which low amplitude signals are not emphasized.
0 to 8 to FH
Adjust the up-converter image enhancer. Set the luminance range for
edge enhancement.
0 to 8 to FH
Adjust the up converter image enhancer. Set the center frequency and
frequency properties for edge enhancement.
3.2MHz: 3.2 MHz ±1.1 MHz
4.5MHz: 4.5 MHz ±1.4 MHz
5.0MHz: 5.0 MHz ±0.7 MHz
4.0MHz: 4.0 MHz ±2.0 MHz
Adjust the up-converter image enhancer. Set the horizontal/vertical ratio
for edge enhancement.
0 to 3 to 7

Extended menu operations

The extended menu can be used with the same procedures
as in the basic menu.