3, and whether the signal input to connector 2 is assigned
to audio channel 2 or 4.
You can set the reference input level with the maintenance
menu item M37: AUDIO CONFIG (see page 120).
(Factory default setting: +4 dB)
Microphone settings
If you have connected a microphone to this unit, you can
set input level, AGC, and limiter values for the
microphone with setup menu items 834, 839, 840, and 841
(see page 116).
Note
An unpleasant sound may be output if you have connected
a microphone to the ANALOG AUDIO INPUT 1 or 2
connector and power the microphone on with the input
level too high. Check the input level setting before
connecting a microphone.
b ANALOG AUDIO OUTPUT 1, 2 connectors (XLR
3-pin, male)
These output analog audio signals.
When the unit is shipped from the factory, the 1 connector
is set to audio channel 1, and the 2 connector is set to audio
channel 2. You can change these settings with setup menu
item 824 ANALOG LINE OUTPUT SELECT (see
page 115).
You can set the output level with the maintenance menu
item M37: AUDIO CONFIG (see page 120). (Factory
default setting: +4 dB)
Non-audio signals are muted.
c AUDIO MONITOR R, L connectors (XLR 3-pin,
male)
This outputs an audio signal for monitoring.
The monitored channel is selected with MONITR L and
MONITR R on page P2 AUDIO of the function menu.
See “Basic Operations of the Function Menu” (page 42)
for more information.
3 Digital audio signal input/output section
1 DIGITAL AUDIO (AES/EBU) IN 1/2, 3/4
connectors
DIGITAL AUDIO (AES/EBU)
IN
1/2
3/4
OUT
1/2
3/4
2 DIGITAL AUDIO (AES/EBU) OUT 1/2, 3/4
connectors