Troubleshooting; Alarms - Sony XDCAM HD PDW-HD1500 Operation Manual

Troubleshooting

Alarms

An alarm (warning message) appears in the time data
display area when an operation is attempted which is
inappropriate for the settings on this unit or the state of the
disc. Both the alarm message and the action to take to
resolve the problem appear in the monitor video section
and on the screen of the external video monitor connected
to the unit.
When the unit is powered on
Alarm message in time Alarm message in video monitor screen
data display area
ADJ. Mode! THE UNIT IS IN ADJUSTMENT MODE.
CHECK THE SWITCHES OF S2701 ON THE
HPR-23 BOARD AND S1 ON THE VPR-99
BOARD.
MENU Ver.UP THE SETUP MENU SOFTWARE HAS BEEN
UPGRADED.
SET THE SETUP MENU ITEMS TO THE
DESIRED SETTINGS.
ILL. SETUP! INVALID SETTINGS SELECTED IN SETUP
MENU.
SET ITEMS IN THE SETUP MENU TO THE
APPROPRIATE VALUES. CONTACT SERVICE
IF THIS ALARM APPEARS AGAIN AFTER
ABOVE PROCEDURE.
Exchg batt! BATTERY NEEDS REPLACING. PLEASE
CONTACT SERVICE.
Update Err! RUN SOFTWARE UPDATE PROGRAM.
R E M O T E !
Example alarm in time data display area
ALARM
REMOTE MODE IS SELECTED.
SET REMOTE/LOCAL/NETWORK
SWITCH TO LOCAL.
Example alarm in monitor video section
When an alarm is displayed, remove the alarm cause by
following the action to take. If the alarm display does not
disappear, contact a Sony service representative.
Please note that there are some alarms which do not appear
depending on the setting of setup menu item 016 ALARM
DISPLAY (see page 102).
See "Setup Menu" (page 99) for more information about
setup menu operations.
Description/action
This appears when the unit is in adjustment
mode.
Contact a Sony service representative.
Reset the settings in the setup menu (see
page 105).
Reset the settings in the setup menu (see
page 105). If the same message appears after
you reset the settings, contact a Sony service
representative.
The NVRAM battery is exhausted. Contact a
Sony service representative.
The software version is not properly updated.
Update the software version again. If the same
message appears after you update the software
version, contact a Sony service representative.
131
Troubleshooting