probst SPEEDY VS-140/200 Operating Instructions Manual page 7

General
The load (stone slabs) which is to be sucked and
transported, must have sufficient inherent stability,
otherwise there is risk of breakage when lifting!
Stone slabs must not be bend when lifting - especially take
care with thin and large-sized stone slabs!
Generally, the load (stones slab) is only to be sucked in the
middle, otherwise the load hangs diagonally under the
device and the load could break - especially when lifting
large stone slabs with a small suction plate.
Standard suction plates are not suitable for the transport of
glass plates!
Only suction plates of the manufacturer PROBST shall be used!!!
Some suction plates which can be mounted to the device will reduce its carrying capacity.
·
The maximum load is indicated on each suction plate.
Use only suction plates which are approved for this device!
·
Do not exceed the maximum carrying capacity of the suction plates!
Danger: Load (stone slabs) will fall down!
5270.0011/5270.0012/5270.0013/5270.0014 V3
7 / 25
GB