Maintenance; General; Maintenance Plan; Suction Pads / Seals - probst SPEEDY VS-140/200 Operating Instructions Manual

Maintenance

9 Maintenance
9.1

General

9.2

Maintenance Plan

Inspect the safety devices:
- Vacuum gauge OK?
Electrical equipment OK? Cable glands tight?
Vacuum hoses in good condition (no cracks, not kinked, no
abrasion, free of leaks)?
All connections (hose clamps, etc.) tight?
Instruction plate, rating plate and load plate still mounted on
the device?
Operating instructions available?
Operating personnel familiar with operating instructions?
Inspect load-carrying part (such as suspension) for
deformation, wear and other damage.
Clean and inspect suction pads. Must be free of cracks, lip
must be smooth, etc. Replace if necessary.
Clean the air filter
Is the inspection sticker up to date?
General condition of the device.
Leak test
9.3

Suction Pads / Seals

5270.0011/5270.0012/5270.0013/5270.0014
The device may be installed and maintained only by qualified personnel such as
mechanics and electricians.
Always disconnect the electric power before starting any maintenance work.
The fans must not be opened during the guarantee period as this will entail loss of
guarantee cover.
After any repair or maintenance work, check the safety devices as described in the
section "Safety".
Remove any foreign bodies and contamination such as adhesives, glue, sawdust, dust,
etc. sticking to the seals at least once a week. Use glycerine to clean the seals.
Immediately replace damaged seals (tears, holes, waves).
Do not use petrol (gasoline).
Use cleaning agent to clean the device (do not use petrol (gasoline) or aggressive or
corrosive fluids to clean the device. The hoses will otherwise become leaky or be
destroyed).
Suction plates must always be replaced completely. The bolts of the suction plate can be
loosened more easily by heating.
V3
Interval
Daily Weekly Monthly Every 6
X
X
X
X
X
23 / 25
Every 12
months months
X
X
X
X
X
X
x
X
X
X
X
GB