Lifting Eye With Safety Chain; Handle Extension - probst SPEEDY VS-140/200 Operating Instructions Manual

Operating
7.4 Lifting eye with safety
chain
Danger
7.5

Handle extension

5270.0011/5270.0012/5270.0013/5270.0014
When using the device SPEEDY VS" at a lifting equipment (e.g. excavator) the
„Lifting eye with safety chain – VS-XL-EH" should be installed.
Lift the device with the sucked load just a little (10-20 cm), then remove the safety
chain (1) from the chain case (2) and throw it under the lifted load.
Never grip with the hands under the load (stone slab) – danger of squeezing the
hands!
Suspend and tighten the security chain (1) on the other side of the device (place the
end of the chain into the chain case (2).
The safety chain must fit tightly to the load, so that load with vacuum failure (e.g. due
to power failure) is held by the security chain.
When laying large stone slabs up to 1,2 m (47 ") the extended handles „VS-XL-HG" (B)
always should be installed, instead of the standard handles, so that the feet are
outside of the danger zone.
Standard-Handles
V3
(A)
Long Handles VS-XL-HG
21 / 25
(2)
(B)
(1)
GB