Description; Components Of The Lifting Device; Controls; Push Switch - probst SPEEDY VS-140/200 Operating Instructions Manual

Description

5 Description
5.1

Components of the Lifting Device

Parts with safety functions appear in bold type
Pos Description
1 Operator handles
2 Upper part of the device with blower motor
3 Suction pad
4 Ventilating flap
5 Lower part of the device
5.2

Controls

5.2.1

Push switch

5.2.2

Operating lever

Attention
5.2.3

Vacuum generator

5.2.4

Suction pads

Danger
5270.0011/5270.0012/5270.0013/5270.0014
The push switch is used for switching the unit on and off.
The operating lever is used for releasing the load by opening the venting valve.
This lever may be actuated only when the load is resting on a solid surface.
When the lever is actuated, the vacuum is released immediately and the unit can be
lifted off the workpiece.
The vacuum is generated by an electrically driven blower.
The suction pads are designed to lift various items. Only items with smooth, air-tight
surfaces are suitable for vacuum lifting.
To generate vacuum, the suction pad must be in contact with and attached to the
load.
The suction pad must always be positioned in the centre of the workpiece in order to
ensure even distribution of the load. If the suction pad is positioned off-centre, the
workpiece may suddenly drop from the unit during lifting and lowering operations,
since the load is then one-sided.
V3
Pos Description
6 Cover of the device
7 Operating lever
8 Push switch
9 Vacuum gauge
14 / 25
GB