Factory Default Settings; Web Interface (Username And Password); Device Lan Ip Settings; Isp Setting In Wan Site - Billion BiPAC 7404V Series User Manual

Factory Default Settings

Before configuring your, you need to know the following default settings.

Web Interface (Username and Password)

Username: admin
Password: admin
The default username and password are "admin" and "admin" respectively.
If you ever forget the username/password to login to the router, you may
press the RESET button up to 6 seconds to restore the factory default
settings.
Caution: After pressing the RESET button for more than 6 seconds, to be sure you power
cycle the device again.
Attention
Attention

Device LAN IP settings

IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0

ISP setting in WAN site

PPPoE

DHCP server

DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100

LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.
LAN Port
IP address
Subnet Mask
DHCP server function
IP addresses
distribution to PCs
Chapter 3: Basic Installation
192.168.1.254
255.255.255.0
Enabled
for 100 IP addresses continuing from
192.168.1.100 through 192.168.1.199
VoIP/(802.11g) ADSL2+ (VPN) Firewall Router
WAN Port
The PPPoE function is enabled
to automatically get the WAN
port configuration from the ISP.
17