Troubleshooting - EdgeStar VBR Series Service Manual

Troubleshooting

PROBLEM
Appliance does not
operate.
Appliance is not
cold enough.
Appliance turns
itself on and off
frequently.
The light does not
work.
Vibrations.
The appliance
seems to make too
much noise.
POSSIBLE CAUSE
•
Appliance is not connected to a
power supply.
•
The appliance is turned off.
•
The circuit breaker tripped or a blown
fuse.
•
The temperature is not set correctly.
•
The ambient temperature could
require a colder temperature setting.
•
The door was opened too often.
•
The door was not closed completely.
•
Door is not hermetically sealed.
•
The condenser is too dirty.
•
The ventilation opening is blocked or
too dusty
•
The room temperature is higher than
average.
•
A large number of bottles has been
added to the unit.
•
The door is open too often.
•
The door is not closed completely.
•
The door gasket does not seal
properly.
•
Appliance is not connected to a
power supply.
•
The circuit breaker tripped or a blown
fuse.
•
The light was switched off on the
control panel.
•
The appliance is not properly level.
•
The rattling noise may come from the
flow of the refrigerant, which is
normal. As each cycle ends, you may
hear gurgling sounds caused by the
flow of refrigerant in your appliance.
If temperature fluctuations occur, the
contraction and expansion of the
inner walls may cause popping and
cracking noises.
•
The appliance is not properly level.
REMEDY
•
Connect the appliance.
•
Switch on the appliance.
•
Switch on circuit breaker or replace
fuse.
•
Check the set temperature.
•
Set a higher temperature.
•
Do not open the door more often
than necessary.
•
Close door properly.
•
Check the door seal and clean or
replace.
•
Clean the condenser when
necessary.
•
Clear the obstructions and clean
the dust.
•
Put the appliance in a cooler place.
•
Leave the appliance to work for a
while until the set temperature has
been reached.
•
Do not open the door more often
than necessary.
•
Close door properly.
•
Check the door seal and clean or
replace.
•
Connect the appliance.
•
Switch on circuit breaker or replace
fuse.
•
Switch on the light.
•
Level the appliance with the
adjustable feet.
•
Level the appliance with the
adjustable feet.