Alarm System - EdgeStar VBR Series Service Manual

ALARM SYSTEM

Temperature Display
During normal operation, the temperature display on the control panel will show the temperature
inside the appliance.
The temperature display will flash if:
•
A different temperature is being set
•
The temperature in deviates by more than 5°C from the set temperature. Note: To view the
"set" temperature at any time, touch the "UP" or "DOWN" mark, the "set" temperature will
temporarily flash in the LED display for 5 seconds.
If the LED readouts display the icon "--" and flash, that means the display temperature is out of
the range from -9 to 37ºC for Celsius degree and from 16 to 99ºF for Fahrenheit degree. That is
normal.
Temperature Alarm
An alarm will sound if the temperature rises or falls outside the temperature range. The
temperature display will flash at the same time. The temperature the appliance is set at
determines the temperature the appliance recognizes as being too warm or too cool.
The alarm will sound and the temperature display will flash if:
•
When there has been a lengthy interruption to the power supply.
•
When too many items have been put into the unit at one time.
•
When the door is not been closed tightly.
Door Alarm
If the door has been left open for more than 60 seconds, the alarm will sound. After closing the
door, once the set temperature has been reached in the appliance, the alarm stops and the
temperature display stops flashing. However, if the noise disturbs you, you can switch the alarm
off before this if you wish by pressing the POWER key once. The alarm will stop. The
temperature display will continue to flash until the set temperature has been reached. The
display will then light up constantly, and the alarm system is fully active again.