Unpacking Parts And Features; Troubleshooting - EdgeStar FP430-FP860 Owner's Manual

UNPACKING PARTS AND
FEATURES
Your portable freezer is supplied with all the accessories you need to enjoy
refrigeration almost anywhere. Below is an image of the freezer and its
respective features.
5
6
1. Latch
2. Insulated lid
3. Wire baskets
4. Side handle
5. DC power cord
6. AC power cord
7. Drain plug
4
2
1
4
3
7
Dirt from the condenser should be cleaned by a qualified technician
when necessary.

TROUBLESHOOTING

Problem Cause
The compressor runs for The voltage is not in the
1 to 5 minutes and correct range.
stops.
The refrigerant has
leaked.
The compressor runs
but the inner liner does
not get cold.
The system is blocked.
The ice layer on the
evaporator is too thick.
The door is being opened
and closed too
frequently.
The inner liner is very The freezer is
cold and the overloaded.
compressor runs
continuously.
The condenser is not
well-ventilated.
The temperature sensor-
tube is out of the
evaporator or the
controller is faulty.
The controller is faulty
(the power indicator is
The compressor does not on).
not run.
The thermostat is set too
high and the ambient
Solution
Switch off the power
and restart when the
power is normal.
Contact customer
service representatives-
online via email at
service@edgestar.com
or by telephone at 1-
866-319-5473.
Defrost.
The door should be
opened as little as
possible.
Remove some products.
Select a well-ventilated
place.
Contact customer
service representatives
online via email at
service@edgestar.com
or by telephone at 1-
866-319-5473.
Contact customer
service representatives
online via email at
service@edgestar.com
or by telephone at 1-
866-319-5473.
Use as a freezer.
9