Configuration Parameters - Siemens S120 Instructions Manual

COMPENSATIONS – COMPENSAZIONI
p21570 Switch tipologia olio
p21571 P.X1
p21572 P.X2
p21573 P.X3
p21574 P.X4
p21575 P.X5
p21576 P.X6
p21577 P.X7
p21578 P.X8
p21579 P.X9
p21580 P.X10
p21581 P.X11
p21582 P.X12
AUTOTUNING - AUTO REGOLAZIONE
p21600 Torque Measure without load
p21601 Torque Measure with full load
TORQUE VALUES - VALORI COPPIA
p21590 Ascending Torque Min Value
p21591 Ascending Torque Max Value
p21592 Ascending Comp Value
p21595 Descending Torque Min Value
p21596 Descending Torque Max Value
p21597 Descending Comp Value
ENCODER – ENCODER
p22502 Azzeramento
p22503 Sviluppo puleggia
p22504 moltiplica x mill/micron
p22506 imp encoder
p22509 OFFSET di posizione al TERRA
NOTE: (*) all speeds are expressed in rpm% compared to the rated motor speed (usually 3000r / min)

10.4 CONFIGURATION PARAMETERS

For both directions, it is necessary to adjust some values to your system:

Set the desired value for the high-speed P21507 (2.2.6) (P21537 (2.3.6) for downward).

Set the desired value for the low speed P21512 (2.2.7) (P21542 (2.3.7) for the downward).

Set the desired value for the inspection speed P21514 (2.2.9) (P21544 (2.3.9) for the
downward).
After the modify of the parameters of interest, it is always necessary to save the new values on
the hard memory of the Control Unit (Copy from RAM to ROM), in order to prevent a loss of data at the
first shut down (voluntary or accidental). Using STARTER software, you have to switch ONLINE, then
press the push button Copy from RAM to ROM
chapter 9 for the setup by BOP
Siemens S120_EN_rev06-08062017.docx
0H
0.900
0.800
0.200
0.300
0.250
0.200
1.000
1.600
1.000
0.200
2.900
1.000
0H
0H
29.731 Nm
51.892 Nm
0.030 %
-8.194 Nm
9.558 Nm
0.035 %
7789511
3354
1
4096
1880
. Alternatively, see the procedure described to the
10-4