Siemens S120 Instructions Manual page 65

-
Press the "P" key.
-
The required parameters can be selected using the arrow keys.
Press the "FN" key  "r00000" is displayed
-
Press the "P" key  changes back to the operating display
-
Parameter display
The parameters are selected in the BOP20 using the respective identification number (Pxxxxx).
The parameter display is reached from the operating display by pressing the "P" key.
Parameters can be searched for using the arrow keys.
The parameter value is displayed by pressing the "P" key again.
You can toggle between the drive objects by simultaneously pressing the "FN" key and an arrow key.
You can toggle between "r00000" and the parameter that was last displayed by pressing the "FN" key in the
parameter display.
(es: P0013[0])
Figure 51 Parameter display
Siemens S120_EN_rev06-08062017.docx
Drive objects:
01: Control Unit (CU)
02: Drive
03: Other objects
9-3