Section 4 Initialize The Card Configuration - Eaton ConnectUPS Web/SNMP Card Quick Start Instructions

Section 4 Initialize the Card Configuration
NOTE
NOTE
To initialize the card configuration:
1. Verify that the serial cable (supplied) connects the card's COM port to the
computer's COM port. Also verify that the UPS is on and in normal mode.
2. Click Start in the computer Start bar. Type Device in the search box. Select
Device Manager in the list above the search box. The Device Manager
opens.
3. Locate Ports (COM & LPT) in the list and click the adjacent "plus box" to
expand the selection. Make a note of the COM port you are using.
4. Open HyperTerminal.
5. Respond Yes or No to the message asking if you want to make
HyperTerminal your default terminal emulation program. The New
Connection dialog opens.
6. Optional. When the Connection Description dialog box opens, enter a name
for this connection and click OK. Otherwise, click Cancel.
7 . In the New Connection dialog, make the menu selection File > Properties.
On the screen that displays, select New Connection Properties.
8. Click the Connect To tab. From the "Connect Using..."drop-down list, select
the COM port that you are using (see Figure 5).
Eaton ConnectUPS Web/SNMP Card Quick Start Instructions 164950185—Rev D 9
These instructions show HyperTerminal screen images, but you
can use the terminal emulation program of your choice, such as
PuTTY.
Before you start initializing the card configuration, you will need
to know which COM port you are using on your computer.