Rf Shield Test Report - GE SIGNA Voyager Pre-Installation

c. Take a reading and record the value

3.3.9 RF Shield Test Report

A test report must be prepared by the testing organization performing the shielding
effectiveness and ground isolation resistance tests for the RF shielded room. The test report
includes data necessary for the evaluation of the shielding effectiveness performance and
ground isolation of the RF shielded room. The test report must contain the following information:
1. Name of the owner organization or hospital
2. Name of testing organization
3. Identification name for the RF shielded room being tested
4. Name of test personnel
5. Date of test
6. Frequencies tested
7. Shielding effectiveness measured for each test point location (each test point location must
be identified in the test report)
8. RF shielded room drawing showing each test point location
9. List any changes pertinent to the test setup or SE results (e.g., limited separation distance of
antennas, limited access to test points, etc.)
10. Ground isolation test results and the condition of the room when tested (e.g., RF room
completed without internal finishes and no electrical connections)
11. Pass/Fail conclusion
12. The following information for each piece of all calibrated equipment used for measurement:
a. Manufacturer
b. Model
c. Serial number
d. Current calibration date and calibration due date
13. Results of the table anchor pull test
Recommended additional information:
1. Location of RF shielded room relative to the whole building where it is installed
2. Pictures of RF shielded room shielding effectiveness test showing:
a. Overall view of RF shielded room
b. Window(s), door(s), filter(s), skylights, patient view window
c. Blank penetration panels
d. Installed additional penetration points (waveguides, vents, ducts, etc.)
e. Test set-up for reference level measurement
Chapter 7 Appendix
SIGNA Voyager Pre-Installation
Direction 5680008–1EN, Revision 2
165