Installing Batteries - SCS Sentinel WDP200 User Manual

Installing Batteries

Receiver
Installing Batteries
Installing Batteries
The rechargeable Ni-MH battery (3.6V, 800mAh)
Receiver
come with your receiver. Install the batteries before use.
Receiver
The rechargeable Ni-MH batteries (AAA size,
come with your receiver. Install the batteries before use.
The rechargeable Ni-MH batteries (AAA size,
1 1
come with your receiver. Install the batteries before use.
1.
1.
2. Plug the Rechargeable Ni-MH
6
battery pack into the battery
2. Plug the Rechargeable Ni-MH
6
compartment.
2 Plug the Rechargeable Ni-MH battery
battery pack into the battery
pack into the battery compartment.
3. To replace the battery cover, slide the
compartment.
cover up until it snaps in place.
3. To replace the battery cover, slide the
3 To replace the battery cover, slide the
cover up until it snaps in place.
cover up until it snaps in place.
Notes:
Notes:
The batteries need to be replaced if they don't
r e c o v e r t h e i r f u l l s t o r a g e c a p a c i t y a f t e r
The batteries need to be replaced if they don't
recharging.
r e c o v e r t h e i r f u l l s t o r a g e c a p a c i t y a f t e r
When replacing the batteries, always use some
recharging.
good quality Ni-MH battery.
When replacing the batteries, always use some
Notes:
good quality Ni-MH battery.
● The batteries need to be replaced if they don't
recover their full storage capacity after recharging.
● When replacing the batteries, always use some good quality
Ni-MH battery.
3.6V, 800mAh)
3.6V, 800mAh)
EN ::: 7
EN