SCS Sentinel WDP200 User Manual page 10

Installation Instruction (continued)
Receiver
Installation Instruction (continued)
Installation Instruction (continued)
1. If you would like to put your on the desktop, please
Receiver
Receiver
install the bracket as figure 1.
1. If you would like to put your
1. If you would like to put your
install the bracket as figure 1.
install the bracket as figure 1.
2. If you prefer to mount the on the wall, please remove
the bracket and do the following steps as figure 2.
2. If you prefer to mount the
2. If you prefer to mount the
a. Install the two self-tapping screws at a distance of 60mm from
the bracket and do the following steps as figure 2.
the bracket and do the following steps as figure 2.
each other and located on a horizontal line.
a. Install the two self-tapping screws at a distance of 60mm from
a. Install the two self-tapping screws at a distance of 60mm from
b. Slowly slide the unit down until it snaps into place.
each other and located on a horizontal line.
each other and located on a horizontal line.
b. Slowly slide the unit down until it snaps into place.
b. Slowly slide the unit down until it snaps into place.
Figure 1:
Figure 1:
8
Figure 1
8
Figure 2
Figure 2
Figure 2
receiver on the desktop, please
receiver on the desktop, please
receiver on the wall, please remove
receiver on the wall, please remove
EN
Mounting
Mounting
Mounting
pins
pins
pins
EN ::: 9