Connecting The Drive; Mounting The Drive - Sony CDU926S User Manual

Connecting the Drive

Attach one end of the flat cable (SCSI cable) to the connector on the
rear of the CDR drive.
Sony CDU926S Drive Unit
Audio Out
Connector
Note
The red edge of the flat cable should be positioned next to the power
supply connector. It is important that this cable be connected firmly and
correctly.
Interface Card
If your computer has a Sound Card, connect the audio cable (not
supplied) to the AUDIO OUT connector at the rear of the CD-R drive.
Sound Card
12 Installing the Drive Unit into the Computer
Interface Connector
Power Supply Connector
Red Edge
Audio
Cable
Red Wire
CD-R Drive
Flat Cable
CD-R Drive
Audio Cable
Audio output connector
Flat Cable

Mounting the Drive

The audio output connector recommended is Molex 5159PBT contacts and
5051-04 housing or 5103 PBT contacts and 5102-04 housing.
Pin assignment
Left signal
GND
1
Route the flat cable and audio cable through the drive bay from the
front of the computer and insert the CD-R drive into the bay as shown.
Secure the CD-R drive to the frame by using the prepared screws.
Mounting Screws
Audio Cable
Note
If you cannot secure the CD-R drive to the drive bay, you may need to
install slide rails (not included) to the CD-R drive. Refer to your
computer user's guide for additional information.
Installing the Drive Unit into the Computer
Right signal
GND
Flat Cable
13