Related Manuals for Sony CDU 5211 Series
Summary of Contents for Sony CDU 5211 Series
- Page 1 CDU 5211 Series CDU 5211 Series CD-ROM Drive User’s Manual Revision 1 Copyright 2001 - Sony Australia NOTE: This manual is subject to change without notice. Printed in Australia...
- Page 2 STRALEN MED OPTISKA INSTRUMENT. VARO! AVATTAESSA OLET ALTTIINA NÄKYMÄTTÖMÄLLE LASERSÄTEILYLLE. ÄLÄ TUIJOTA SÄTEESEEN ÄLÄKÄ KATSO SITÄ OPTISEN LAITTEEN LÄPI. © 2001 - Sony Australia © 2001 - Sony Australia Serial No. _______________ This label is located on the drive unit’s internal chassis.
- Page 3 Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. © 2001 - Sony Australia © 2001 - Sony Australia This CD-ROM Drive Unit is classified as a CLASS 1 LASER PRODUCT.
-
Page 4: Table Of Contents
© 2001 - Sony Australia © 2001 - Sony Australia Warnings and Precautions Introduction Features ...8 Software Requirements...9 Using the Drive Front Panel ...10 “Maximum Speed Choice” function...11 Installing the Drive System Requirements...12 Hardware Installation...12 Connections & Settings ...13 Connecting the IDE cable ...14... - Page 5 Keep your discs clean. Using soft, dust-free cloth to clear the surface of the disc. · Do not drop or jolt the drive. · Keep the area around the CD-ROM drive clean from dust, smoke, and other contaminants. © 2001 - Sony Australia © 2001 - Sony Australia...
-
Page 6: Introduction
Features The CDU 5211 is an internal CD-Rom (Compact Disc - Read Only Memory) drive unit designed for use with personal computers. It comes with the following features: General • Speed: 52X max / 40X default. • “Maximum Speed Choice” function. -
Page 7: Using The Drive
52X. NOTE: Physically damaged discs may void warranty - refer to “Warnings & © 2001 - Sony Australia © 2001 - Sony Australia You are confident that the disc been used is in good condition and free from marks and scratches. -
Page 8: Installing The Drive
If your system supports the CS setting you can set the jumper to the “CS” position. The Master/Slave setting will then be made automatically depending on your hardware Configuration. No jumper is then required on the “MA” or “SL” pins. © 2001 - Sony Australia © 2001 - Sony Australia Rear of Drive... -
Page 9: Connecting The Ide Cable
Cannot read data on discs. Device2 (Slave) No sound. PC Mother Board Figure 2 © 2001 - Sony Australia © 2001 - Sony Australia http://www.sony.com.au/support/itp Action Check DC power cable connection. Check IDE interface connections. Check the MASTER/SLAVE settings of all devices. -
Page 10: Specifications
1.5 amps 0.03 amps 0.01 amps +/- 5% and less than 100m Vp-p ripple voltage +/- 10% and less than 200m Vp-p ripple voltage © 2001 - Sony Australia © 2001 - Sony Australia Operating Temp Humidity Altitude Non Operating...