Step 6: Connecting the Drive
Attach flat SCSI cable to connector at rear of CD-R drive.
CDU948S Drive Unit
Audio Out
Connector
Notes:
The 50 pin flat SCSI cable must be firmly attached with its red edge
(Pin 1) positioned next to the power supply connector.
If your computer has a Sound Card, an Audio Cable may be connected to
the rear of the CD-R drive. Contact a local dealer if cable is required.
12
Hardware Installation
Pin 1
Interface Connector
Power Supply Connector
Red Edge
Audio
Cable
Red Wire
Step 7: Mounting the Drive
SCSI
Flat Cable
Step 8: Connecting the Power Cable
Insert the CD-R drive into computer front as shown, routing cables
accordingly. Secure drive to frame with appropriate screws.
Mounting Screws
Audio Cable
Note:
Slide rails (not included) may be necessary if CD-R drive cannot cannot be
secured. Refer to computer's User's Guide for more information.
Locate an available power supply cable, within computer, and connect it to
the rear of CD-R drive as shown.
Power Supply
Connector
Power Supply Cable
Note:
The power supply cable connector is designed to fit one way, do not force
it upside down, this could damage drive and void the warranty.
Flat Cable
+ -
+ -
5V 5%
GND 12V 10%
DC INPUT
Hardware Installation
13