Precautions; Example Of System Setup; Installing The Drive Unit Into The Computer; Getting Started - Sony CDU926S User Manual

Precautions

Installation
Avoid placing the drive in a location subject to:
– high humidity
– high temperature
– excessive dust
– mechanical vibration
– direct sunlight.
Use the drive in a horizontal or vertical position. Do not use it in a tilted
position.
Operation
Do not move the drive during operation. This may cause it to
malfunction during reading or writing.
Avoid exposing the drive to sudden changes in temperature as
condensation may form on the lens inside the drive as a result. Should
the surrounding temperature suddenly rise while the drive is on, wait at
least one hour before you turn off the power. Operating the drive
immediately after a sudden increase in temperature, may result in a
malfunction during reading or writing.
Transportation
Keep the original packing materials for future transport of the drive.
Remove the caddy before moving the drive and, if you take the drive
out of the computer, repack the drive as you received it.

Example of System Setup

To use the CD-R device, the following components are required:
Computer (IBM-PC/AT* compatible)
SCSI-Host adapter
SCSI-Interface cable (50 to 50 pin flat cable)
Software (Device driver, utilities)
* IBM-PC/AT is a registered trademark of International Business Machines Corporation.
8 Precautions/Example of System Setup

Installing the Drive Unit into the Computer

As you go through this section, you may wish to refer to your computer's
manual for a more detailed description of how to install internal drives.

Getting Started

Prepare the necessary parts and tools that have not been supplied:
– Screwdriver
– four screws 3 mm in diameter (Screws must not extend more than
4.0 mm into the side panels or the bottom plate.)
– two mounting rails if your computer has mounting tracks.
Unplug the computer and disconnect the cables attached to the
back for your own safety. Do not turn on the power of the computer
before completing the entire installation process.

Setting the Jumpers

Set the jumpers on the rear panel of the drive unit in accordance with the
configuration of your computer system.
The jumpers are preset, as illustrated below, at the factory.
DEVICE TYPE
ID SELECT
0 1
PREVENT/ ALLOW
2
TEST MODE
KEY
= Pin removed
Terminators
Installing the Drive Unit into the Computer 9