Command Line Interface (Cli) - Korenix JetWave 2111 Series User Manual

5.2 Command Line Interface (CLI)

The Gateway provides the Command Line Interface (CLI), you can access it through the
console or Telnet. The Command Line Interface (CLI) is the user interface to the Gateway's
embedded software system. You can view the system information, show the status, configure the
switch and receive a response back from the system by keying in a command.
The below screen is the login screen of the Gateway. The default username/password is
admin/admin, it is the same as Web GUI. Once you modified it from other configuration interface,
please type the new name/password to login.
There are some different command sets. Each command sets has its own access ability and
available command lines. These command sets are:
SHOW: This is Read Only command to show the current setting and status of the Gateway.
SET: This is Write command to change the current setting.
LIST: This is Help command to show the usage information of the command.
Del: This is Delete command to delete the applied settings.
Exit: To exit the CLI. It is logout command.
Use "Tab↹ " key can help you find the correct command and complete the command
Note:
no matter you want to Read or Write easier.
JetWave 2111/2411 Series User Manual
Page 113