Fail To Login The Web Gui - Korenix JetWave 2111 Series User Manual

Enter the name of Account (Default: admin) and password (Default: admin) respectively and click
"Login" to login the main page of the device. As you can see, this management interface provides main
options in the above, which are Status, System, Management, Tools, Save, Reboot and Logout.
Note:
The username and password are case-sensitive!

3.4 Fail to login the Web GUI

If you failed to login the web GUI, there are something you can do for troubleshooting.
1. Please disable the firewall setting of your browser. The firewall setting may block the connection
from your PC to the device.
restore as well. Note that after finished the setting, re-enable your firewall to protect your PC.
2. Check the IP Setting, your PC and managed device must be located within the same subnet.
3. The Web UI connection session of the device will be logged out automatically if you don't give any
input after 30 seconds. After logged out, you should re-login and key in correct user name and
password again.
Figure - Main Page
The firewall may stop the firmware upgrade, configuration backup and
JetWave 2111/2411 Series User Manual
Page 23