Basic Factory Default Settings - Korenix JetWave 2111 Series User Manual

Chapter 3 Prepare for Management
The JetWave 2111/2411 Series supports Web GUI Configuration, Simple Network Management
Protocol (SNMP), Telnet and Diagnostic Command Line Interface for management and Window Utility
helps you discover the device cross network, basic IP setting, firmware management...etc.
This chapter describes the preparation for management. In your first time access the device, you can
refer to the Basic Factory Default Settings to know the default settings and the default IP of the device.
The chapter also tells you how to login the Web-based interface, Diagnostic Console. If you forget IP
address you changed, you can use Korenix View Utility (refer to next chapter) to discover the devices'
IP address and then access it.

3.1 Basic Factory Default Settings

We'll elaborate the JetWave 2111/2411 Series basic factory default settings. You can re-acquire
these parameters by default. This info is easier for you to find the device and access the switch's
configuration interface. For further info, please refer to configuration guide of the feature set.
Table 1 JetWave 2111/2411 Basic Factory Default Settings
Features
Username
Password
Model Name
Device Name
Default IP at Bridge Mode (JetWave 2111/2411 Default)
Access Type
IP Address
Subnet Mask
Default Gateway
Primary DNS Server
Secondary DNS Server
Remote Settings
Remote Management
Privacy
Even Warning Type
Version
Server Port:
JetWave 2111/2411 Series User Manual
Factory Default Settings
admin
admin
JetWave2111 (2411 depends on
which model you access)
korenixXXXXXX (X represents the last 6
digits of Ethernet MAC address)
Static IP
192.168.10.1
255.255.255.0
0.0.0.0
0.0.0.0
0.0.0.0
Telnet, SNMP, SNMP Trap, Email Alert
WLAN association, Authentication fail,
Configuration Changed
2/3
161
Page 20