Power Installation - Korenix JetWave 2111 Series User Manual

2.2 Power Installation

2.2.1 DC Input
1. There is one 6-pin terminal block within the package for screwing the DC wires. It is a good
practice to turn off the system power, and to unplug power terminal block before making wire
connections.
2. Insert the positive and negative wires into the V+ and V- contact on the terminal block
connector. Tighten the wire-clamp screws to prevent DC wires from being loosened. The
range of the suitable electric wire is from 9 to 30 AWG.
3. The typical and suggest power source is DC 24V, the acceptable range is range from
9~30V.
4. The single DC power can be redundant. You can connect one power to typical power source
and the other to battery/UPS as backup.
JetWave 2111/2411 Series User Manual
Page 11