I/O Configuration - Korenix JetWave 2111 Series User Manual

JetWave 2111/2411 Series User Manual

2.3 I/O Configuration

2.3.1 Wiring your Ethernet Port
There are 1 Fast Ethernet port. The 1 port is standard RJ-45 form factor. They can support
10Base-TX, 100Base-TX. The 10/100Base-TX also support both full or half duplex mode. All the
Ethernet ports will auto-detect the signal from connected devices to negotiate the link speed and
duplex mode. Auto MDI/MDIX allows users to connect another switch, hub or workstation without
changing straight through or crossover cables. In some cases, the MDI/MDI-X may requests the
connected device support auto-negotiation.
Available Cable Type:
10Base‐T: 2‐pair UTP/STP Cat. 3, 4, 5 cable (100m)
100 Base‐TX: 2/4‐pair UTP/STP Cat. 5 cable (100m)
Wiring STP Cable: STP (Shielded Twisted Pair) cable is preferred. The device is an
EN50121-4 certificated product and usually install in harsh environment, part of the EMS
protection are based on STP cable, for example the Surge protection of front Ethernet ports. STP
cable can provide better field protection. It is MUST for the device installation in harsh
environment.
2.3.2 Reset
There is one Reset button located on the front of the device. This is design for user to reboot the
system port or force reset the configuration to default. The function is depended on how much
time you press the button.
Press 3 seconds to reboot the device.
Press more than 7 seconds can reset the configuration to default.
Page 12