Table of Contents
Advertisement
gACC-499E/U Communication unit
gACC-499E_U_Manual_EN.doc
2.
Construction
2.1
Build-up
Battery connector 2.1
Battery connector 1.1
DIP-Switch
(See below for
description)
Connector USB
configuration cable
SIM card
Status display (LED)
Antenna connection
2.2
DIP-Switch
No.
1 - On/Off
2 - No Sleep
3 - LEDs On
4 - Test mode
5 - Config 1
6 - Config 2
7 - Encoder On
8 - MU Power
Function
ON = Operating mode
Should be switched ON at normal operating mode!!
ON = Disable sleep mode, the device will not go to sleep.
Should be switched OFF at battery operating mode!!
ON = Status display on.
Should be switched OFF at battery operating mode!!
ON = Activate test mode
Should be switched OFF at normal operating mode!!
ON = Encoder operating mode
OFF = gAVC 1200 operating mode
Can be used to activate Log Level 0. This function can only be activated by
restarting the device after setting the switch.
ON = Interface gAVC 1200 or Encoder on.
Should be switched ON at normal operating mode!!
ON = Power supply to EVCD enabled. (By externally powered EVCD)
Should be switched OFF at battery operating mode!!
GA-02.035-EN-30.05.17
Page 5 of 46
Fuse power supply
EVCD (mains power
supply only)
Removable dividing
wall
Terminals intrinsically
safe side. ( For
connection details see
below)
PA-Terminals
PA-Klemmen
Advertisement
Table of Contents
