Integra DTR-7.6 Series Service Manual page 62

QQ
3 7 63 1515 0
ADJUSTMENT AND CONFIRMATION PROCEDURES 1
Idling current adjustment
Before Idling current adjustment, turn the trimming resistors R6040 to R6046 to counter-clockwise.
Connect the DC voltmeter at the sockets P6080 to P6086 via the carbon resistors 100 ohm 1/4W.
DC voltmeter
After turn POWER to ON, adjust the trimming resistors R6040, R6041 and R6042 so that the reading of
voltmeter becomes 2.5 mV. (Front and center channels)
Adjust the trimming resistors R6043, R6044, R6045 and R6046 so that the reading of
voltmeter becomes 1.5 mV. (Surround and surround back channels)
After adjustment, attach the top cover.
Confirm the voltage of points above after about five minutes.
Front and center channels
When less than 9.0 mV, readjust the resistors above so that the voltage becomes 9.0 mV.
When 9.0 mV to 11.0 mV, you are not necessary to adjust.
When more than 11.0 mV, readjust the resistors above so that the voltage becomes 11.0 mV.
Surround and surround back channels
When less than 6.0 mV, readjust the resistors above so that the voltage becomes 6.0 mV.
When 6.0 mV to 8.0 mV, you are not necessary to adjust.
When more than 6.0 mV, readjust the resistors above so that the voltage becomes 8.0 mV.
Note: No load and No signal
TE
L 13942296513
R6046
JL6006B
P6086
NAAF-8682
JL6200B
Confirmation of protection circuit
1. Confirmation of operation of speaker relay
Confirm that the speaker relays turn ON approximate 5 seconds after the power switch is turned ON.
Confirm that the speaker relays turn OFF immediately after the power switch is turned OFF.
2. Confirmation of DC detection circuit
Press and hold down CD button, then press STANDBY/ON button to set the unit to "Test- 1".
www
After "Test- 1" on the FL tube light on, press DVD button to set the unit to "Test- 1-00".
Apply DC 1.5 to 3.5V to the MULTI-CH INPUT terminal with no load.
Confirm that the speaker relay turns OFF.
.
Apply DC -1.5 to -3.5 V to the MULTI-CH INPUT terminal with no load.
Confirm that the speaker relay turns OFF.
Caution: Don't apply DC voltage more than 1 sec..
http://www.xiaoyu163.com
100 ohm
1/4watts
U064
Surround
back
amplifier
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Jig terminal
Test point
ID+
ID-
Q Q
3 6 7 1 3 1 5
U06
NAAF-8678
P5004B
co
.
9 4 2 8
0 5 8 2 9 9 4 2 8
P3105A
P3103A
P3104A
m
DTR-7.6
9 9
9 9