Powering Up The Camera; Status Light; Next Steps - VADDIO RoboSHOT HDBT Series Installation Manual

Installation Guide for RoboSHOT HDBT High-Performance PTZ Cameras

Powering Up the Camera

Connect camera power.
The camera will run a self-test routine and move to its home position. This will take a few seconds.
When the camera is initialized and ready, video is available and the status light is blue. At this point, the
camera is ready to accept control information.
Note
Wait until the camera finishes initializing before trying to operate or control it.

Status Light

The light in the camera's base indicates its current state.
Blue: Normal operation (blinks once when the camera receives a command from the remote)
n
Red: On-air tally (signal provided by external device via serial connection)
n
Blinking red: Video is muted (UC color scheme only)
n
Purple: In standby mode or booting
n
Yellow: Firmware update in progress
n
Caution
Do not remove power or reset the camera while the indicator is yellow, showing a firmware update in
progress. Interrupting a firmware update can make the camera unusable.
Note
By default, the camera's status light is active during normal operation; however, it can be configured to
remain off when the camera is powered up. The camera may be sending video even if the indicator light is
off.

Next Steps

The camera is now ready to configure and use. This information is available in the Complete Manual for
RoboSHOT HDBTHigh-Performance PTZ Cameras.
22