H3C S5500-SI Series Operation Manual page 16

Operation Manual – VLAN
H3C S5500-SI Series Ethernet Switches
IV. Verification
Verifying the configuration of Device A is similar to that of Device B. So only Device A is
taken for example here.
# Display the information about GigabitEthernet 1/0/1 of Device A to verify the above
configurations.
<DeviceA> display interface GigabitEthernet 1/0/1
GigabitEthernet1/0/1 current state: UP
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0011-2233-5577
Description: GigabitEthernet1/0/1 Interface
Loopback is not set
Media type is twisted pair
Port hardware type is
1000Mbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 9212
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 100
Mdi type: auto
Link delay is 0(sec)
Port link-type: trunk
Tagged
Untagged VLAN ID : 2, 6-50, 100
Port priority: 0
Last 300 seconds input:
Last 300 seconds output:
Input (total):
Input (normal):
Input:
Output (total): 175995 packets, 31290143 bytes
Output (normal): 175995 packets, - bytes
Output: 0 output errors, - underruns, - buffer failures
1000_BASE_T
VLAN ID : 2, 6-50, 100
8 packets/sec 1513 bytes/sec
1 packets/sec 179 bytes/sec
25504971 packets, 13911485028 bytes
14288575 broadcasts, 11111535 multicasts
25504971 packets, - bytes
14288575 broadcasts, 11111535 multicasts
0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
47 broadcasts, 68494 multicasts, 0 pauses
47 broadcasts, 68494 multicasts, 0 pauses
1-14
Chapter 1 VLAN Configuration
0%
0%