Gvrp Configuration Example Ii - H3C S5500-SI Series Operation Manual

Operation Manual – VLAN
H3C S5500-SI Series Ethernet Switches
3
# Display dynamic VLAN information on Device B.
[DeviceB] display vlan dynamic
Now, the following dynamic VLAN exist(s):
2

3.5.2 GVRP Configuration Example II

I. Network requirements
Configure GVRP for dynamic VLAN information registration and update among devices.
Specify fixed GVRP registration on Device A and normal GVRP registration on Device
B.
II. Network diagram
Figure 3-3 Network diagram for GVRP configuration
III. Configuration procedure
1) Configure Device A
# Enable GVRP globally.
<DeviceA> system-view
[DeviceA] gvrp
# Configure port GigabitEthernet 1/0/1 as a Trunk port, allowing all VLANs to pass.
[DeviceA] interface GigabitEthernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] port link-type trunk
[DeviceA-GigabitEthernet1/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 1/0/1.
[DeviceA-GigabitEthernet1/0/1] gvrp
# Set the GVRP registration type to fixed on the port.
[DeviceA-GigabitEthernet1/0/1] gvrp registration fixed
[DeviceA-GigabitEthernet1/0/1] quit
# Create VLAN 2 (a static VLAN).
[DeviceA] vlan 2
2) Configure Device B
# Enable GVRP globally.
<DeviceB> system-view
3-9
Chapter 3 GVRP Configuration