Manual Voice Vlan Mode Configuration Example - H3C S5500-SI Series Operation Manual

Operation Manual – VLAN
H3C S5500-SI Series Ethernet Switches
[DeviceA-GigabitEthernet1/0/1] voice vlan enable
[DeviceA-GigabitEthernet1/0/1] return
IV. Verification
# Display information about the OUI addresses, OUI address masks, and descriptive
strings.
<DeviceA> display voice vlan oui
Oui Address
0001-e300-0000
0003-6b00-0000
0004-0d00-0000
0011-2200-0000
0060-b900-0000
00d0-1e00-0000
00e0-7500-0000
00e0-bb00-0000
# Display the current Voice VLAN state.
<DeviceA> display voice vlan state
Voice VLAN status: ENABLE
Voice VLAN ID: 2
Voice VLAN security mode: Security
Voice VLAN aging time: 100 minutes
Voice VLAN enabled port and its mode:
PORT
--------------------------------
GigabitEthernet1/0/1
<DeviceA>

2.4.2 Manual Voice VLAN Mode Configuration Example

I. Network requirement
Create VLAN 2 and configure it as a voice VLAN.
The voice traffic sent by the IP phones is untagged. Configure GigabitEthernet
1/0/1 as a Hybrid port and as the access port.
GigabitEthernet 1/0/1 works in manual mode. It only allows voice packets with an
OUI address of 0011-2200-0000, a mask of ffff-ff00-0000, and a descriptive string
of test to be forwarded through the voice VLAN.
Mask Description
ffff-ff00-0000 Siemens phone
ffff-ff00-0000 Cisco phone
ffff-ff00-0000 Avaya phone
ffff-ff00-0000
ffff-ff00-0000 Philips/NEC phone
ffff-ff00-0000 Pingtel phone
ffff-ff00-0000 Polycom phone
ffff-ff00-0000 3com phone
MODE
AUTO
2-9
Chapter 2 Voice VLAN Configuration