Mounting The Switch On A Wall - H3C S1850 Series Getting Started Manual

Place the switch upside up on the workbench.
4.

Mounting the switch on a wall

Only an H3C S1850-10P switch can be installed on a wall. The type
of screws used to wall-mount the switch depends on the wall type.
This section uses a concrete wall as an example.
To wall-mount the switch, you need to prepare screw anchors and
screws. The screws must be a minimum of 3 mm (0.12 in) in diameter,
and the screw head must be a minimum of 6 mm (0.24 in) in
diameter.
Figure 5 Screw anchor and screw
To install the switch on a concrete wall:
Drill two holes at the same height on the wall. Make sure the
1.
spacing in between is 160 mm (6.30 in), as shown in
The hole depth and diameter depend on the screw anchors and
screws you use. Make sure you can push the anchors to their
full depth in the holes.
5
Figure 6.