Mounting The Switch On A Workbench - H3C S1850 Series Getting Started Manual

Figure 4 Mounting the switch in the rack
(S1850-28P/S1850-28P-PWR/S1850-52P)
NOTE:
Mounting brackets are not used for bearing the weight of the
switch. A rack shelf is required on the rack to bear the switch
weight.

Mounting the switch on a workbench

Make sure the workbench is clean, sturdy, and reliably
1.
grounded.
Place the switch bottom up, and clean the four recessed areas
2.
in the chassis bottom with a soft and dry cloth.
Remove the four rubber feet from the adhesive strip provided
3.
with the switch and attach them to the recessed areas.
4