Issue
Failure to
access the
Web GUI of
the switch
Appendix A Chassis views and
technical specifications
Chassis views
Front panel
Figure 15 S1850-10P
Troubleshooting procedure
1. Use ping commands to verify network
connectivity at the MS-DOS command
prompt.
Ping 127.0.0.1 to verify that the PC has
TCP/IP installed.
Ping the IP address (default:
192.168.0.233) of the switch to verify that
the switch is reachable from the PC.
2. Verify that no proxy server or dial-up
connection is configured for the web browser.
If these configurations exist, remove them.
3. Configure a local network address for the PC
and then disable and enable the local network
connection.
4. If the issue persists, contact H3C Support.
13