Table of Contents
Advertisement
HOB - DAILY USE
WARNING! Refer to Safety chapters.
IGNITION OF THE HOB BURNER
Always light the burner before you put
on the cookware.
WARNING! Be very careful when you
use open fire in the kitchen
environment. The manufacturer
declines any responsibility in case of
the flame misuse.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut.
It is normal.
In the absence of electricity you can
ignite the burner manually.
Ignition of a hob burner with the
thermocouple
•
For manual ignition put the flame near the
burner. Push the knob for the hob down and
turn it counterclockwise to the maximum gas
flow position
.
•
For integrated ignition on knob push the knob
for the hob down and turn it counterclockwise
to the maximum gas flow position
Keep the knob for the hob pushed for equal or less
than 10 seconds to let the thermocouple warm up.
If not, the gas supply is interrupted.
Adjust the flame after it is regular.
WARNING! Do not keep the knob
pushed for more than 15 seconds. If
the burner does not light after 15
seconds, release the knob, turn it into
the off position and try to light the
burner again after minimum 1 minute.
If after some tries the burner does not
light, check if the crown and its cap
are in the correct position.
If the burner accidentally goes out,
turn the knob to the off position and try
to light the burner again after minimum
1 minute.
8
BURNER OVERVIEW
.
A. Burner cap
B. Burner crown
C. Ignition candle
D. Thermocouple (if applicable)
TURNING THE BURNER OFF
To put the flame out, turn the knob to the off
position
.
WARNING! Always turn the flame
down or switch it off before you
remove the pans from the burner.
A
B
C
D
A
B
C
D
Advertisement
Table of Contents
