Hob - Daily Use; Initial Cleaning; Setting The Time - Zanussi ZCG92386 User Manual

Initial Cleaning

Remove all accessories from the appliance.
Refer to "Care and cleaning"
chapter.
Clean the appliance before first use.
Put the accessories back to their initial position.

Setting the time

You must set the time of day before you operate
the oven.
When you connect the appliance to the
electrical supply or after a power cut, the
display shows 0:00.
1. Press at the same time the
buttons.
Hold the buttons until 0:00 flashes on the
display.
2. Press the or
day.

Hob - Daily use

WARNING!
Refer to Safety chapters.
Ignition of the hob burner
Always light the burner before you
put on the cookware.
WARNING!
Be very careful when you use open
fire in the kitchen environment. The
manufacturer declines any
responsibility in case of the flame
misuse.
The spark generator can start
automatically when you switch on
the mains, after installation or a
power cut. It is normal.
In the absence of electricity you can
ignite the burner manually.
Ignition of a the hob burner without the
thermocouple
• For all hobs without thermocouple first turn
the knob and then push the knob down.
Release knob when the burner lights.
8
and
button to set the time of
After approximately five seconds, the flashing
stops and the display shows the time you set.
Preheating
Preheat the empty appliance to burn off the
remaining grease.
1. Set the maximum temperature.
2. Let the appliance operate for approximately
1 hour.
WARNING!
Accessories can become hotter than
usual.
The appliance can emit an odour and smoke.
This is normal. Make sure that the airflow is
sufficient.
Let the oven cool down. Dampen a soft cloth
with warm water and a little mild washing-up
liquid and use this to clean the oven cavity.
• For integrated ignition on knob push the
knob for the hob down and turn it
counterclockwise to the maximum gas flow
position .
Keep the knob for the hob pushed for equal or
less than 10 seconds to let the thermocouple
warm up. If not, the gas supply is interrupted.
Adjust the flame after it is regular.
WARNING!
Do not keep the knob pushed for
more than 15 seconds. If the burner
does not light after 15 seconds,
release the knob, turn it into the off
position and try to light the burner
again after minimum 1 minute.
If after some tries the burner does
not light, check if the crown and its
cap are in the correct position.
If the burner accidentally goes out,
turn the knob to the off position and
try to light the burner again after
minimum 1 minute.
www.zanussi.com