Table of Contents
Advertisement
GAS BURNERS FOR LPG G30 28-30 mbar
NORMAL POWER
BURNER
Triple Crown
Semi-rapid
Auxiliary
Oven
Grill
GAS CONNECTION
WARNING! Before you connect the
gas, disconnect the appliance from the
electricity supply or switch off the fuse
in the fuse box. Close the primary
valve of the gas supply.
The gas pipe in the appliance has two endings. You
can connect the gas supply to either one of them.
The pipe that is not used must be clogged with the
pipe closer, which added to the appliance.
Use a fixed connections or use a flexible stainless
steel pipes in compliance with the regulation in
force. If you use flexible metallic pipes, make sure
they do not come in touch with mobile parts and
they are not squeezed.
WARNING! When installation is
complete, make sure that the seal of
each pipe fitting does not leak. To
check the seal use a soap solution, not
a flame.
22
GAS RATE g/h
kW
4.0
290.8
2.0
145.4
1.0
2.25
163.6
2.0
145.4
REDUCED POWER
72.7
FLEXIBLE NONMETAL PIPES CONNECTION
If you have an easy access to the connection, you
can use a flexible pipe. The flexible pipe must be
tightly attached by clamps.
In installation always use the pipe holder and the
gasket. The flexible pipe can be applied when:
•
it can not get hotter than room temperature,
higher than 30 °C,
•
it is not longer than 1500 mm,
•
it has no narrowing anywhere,
•
it is not twisted or tighten,
•
it does not get in touch with sharp edges or
corners,
•
it's conditions can be easily checked.
When checking the flexible pipe make sure:
•
it does not show cracks, cuts, marks of burnings
on the two ends and on its full length,
•
the material is not hardened, but shows its
correct elasticity,
•
the fastening clamps are not rusted,
•
expired term is not due.
If one or more defects are visible, do not repair the
pipe, but replace it.
The gas supply ramp is on the rear side of the
control panel.
ADJUSTMENT TO DIFFERENT TYPES OF GAS
WARNING! Let only an authorized
person do the adjustment to different
types of gas.
The appliance is set for liquid gas. You
can change it to natural gas, with the
correct injectors.
The gas rate is adjusted to suit.
INJECTOR MARK
kW
1/100 mm
1.80
0.43
0.35
1.0
1.5
101
71
50
71
71
Advertisement
Table of Contents
