Advertisement
·10 -74
IGNITION SYSTEM
ELECTRICAL SYSTEMS
(350)
hole to pry the cage bar assembly down so that
lock cylinder can be
turned.
See figure
10-90,
view B. After turning cylinder
slightly,
remove
the wire to
avoid wedging,
then remove lock
cylinder in the regular manner (subpar.
b,
above).
3. Stake cage bar in place as shown in
figure 10-91.
Staking
must
not
distort
cage.
Re-
install
lock cylinder and check operation with
key.
If operation is satisfactory, plug the drilled
hole with a small pin #00
x
l/ S"
(Parker Kalon
type "U").
Figure
10-91-Cage Bar Staked in Place
Advertisement
