Programmable Output List - Kipor KP310V1.0 Operation Manual

8.2.2.4Stop normally closed
After Terminal is open （ high potential）,confirmed by Set Input Fault Delay, stop the alarm
immediately. Relevant set input faults LED light up.

8.3 Programmable output list

KP310_1.00 controller has two terminals（terminal 17、18） to customers to set different
parameters.
No.
1
0—reserved
2
1— genset Stop
3
2— genset Preheat
4
3— genset start
5 4— genset idle
6
5— genset running
7 6— genset electric parameters
normal
8
7—system Warning alarm
9
8—system delay stop alarm
10
9—system Stop alarm
11
10—system alarm
12
11—manual mode
13
12—Remote mode
14 13—Oil filter overtime
15 14—Fuel filter overtime
16 15—Air filter overtime
17 16—start failure
Note: if Set Output 1 or Set Output 2 is set as "4— genset idle", start idle Time or Stop idle
Time can't be 0, otherwise there will be no idle output.
Contents
- 23 -
KP310V1.0 Controller Operation Manual
Note
the function reserved
Output when genset in the "Stop " state
Output when genset in the " Preheat " state
Output when genset in the "start " state
Output when genset in the " idle " state
Output when genset in the " norminal
running" state
Output when genset voltage，frequency is
normal
Output when system Warning alarm
Output when system delay stop alarm
Output when system delay alarm
Output when system alarm
Output when system in the "manual mode "
Output when system in the "Remote mode "
Output when Oil filter overtime alarm
Output when Fuel filter overtime alarm
Output when Air filter overtime alarm
Output when genset start failure