Important Safety Instructions - Snap-On ControlTech Micro Calibration Procedure

IMPORTANT SAFETY INSTRUCTIONS

WARNING Risk of flying particles.
Over-torquing can cause breakage. Force against flex stops
on flex head can cause head breakage. An out of calibration
angle wrench can cause part or tool breakage. Broken hand
tools, sockets or accessories can cause injury. Excess force
can cause crowfoot or flare nut wrench slippage.
Read this manual completely before using the
ELECTRONIC WRENCH.
To insure accuracy, work must not move in angle mode.
For personal safety and to avoid wrench damage, follow
good professional tool and fastener installation practices.
Periodic recalibration is necessary to maintain accuracy.
Wear safety goggles, user and bystanders.
Be sure all components, including all adaptors, extensions,
drivers and sockets are rated to match or exceed the torque
being applied.
Observe all equipment, system and manufacturer's
warnings, cautions and procedures when using this wrench.
Use the correct size socket for the fastener.
Do not use sockets showing wear or cracks.
Replace fasteners with rounded corners.
To avoid damaging the wrench: Never use the wrench
with the power off. Always turn ON the wrench so the
applied torque is being measured.
Do not press Power button while torque is applied or while
the wrench is in motion.
Never use this wrench to break fasteners loose.
Do not use extensions, such as a pipe, on the handle of the
wrench.
Check that the wrench capacity matches or exceeds each
application before proceeding.
Verify calibration if dropped.
Make sure the ratchet direction lever is fully engaged in the
correct position.
Verify the calibration of the wrench if you know or suspect
its capacity has been exceeded.
Do not force the head of flex head drives against stops.
Always pull - do not push - on the wrench handle and adjust
your stance to prevent a possible fall should something
give.
WARNING
Electrical shock can cause injury. Metal handle is not
insulated.
Do not use on live electrical circuits.
SAVE THESE INSTRUCTIONS
ControlTech
Electrical Shock Hazard.
1
TM
Micro Wrench